Skip to main content
P
ptc-54931391-Visitor
1-Visitor
February 13, 2015
Solved

Student License Expiration?

  • February 13, 2015
  • 1 reply
  • 2485 views

Hello everyone. I'm a student using Creo 2.0, or at least I was. Recently I tried to load Creo at home and received the following message:

 

--

License request failed for feature

Requesting CREOPMA_Student2...

C:\ProgramData\PTC\Licensing\BK390206EDSTUDENTUNICL_license.dat:(-10)Feature has expired.

--

 

There is more to the message but I think this should be sufficient. I looked up the FAQ section and it sounds like this usually occures when the network card is changed but my network card has not been changed. Any suggestions as to how I should procede?

 

Thanks,

Ryan

Best answer by MartinHanak

Ryan,

open C:\ProgramData\PTC\Licensing\BK390206EDSTUDENTUNICL_license.dat in Notepad and inspect the line similar to the following one:

INCREMENT CREOPMA_Student2 ptc_d 33.0 23-may-2014 uncounted \

The date present in the line is expiration date of your license.

According to my past experience, the Student license is valid of one year, only. When it expires, the student must requst the new license.

Martin Hanak

1 reply

M
MartinHanak24-Ruby IIIAnswer
24-Ruby III
February 13, 2015

Ryan,

open C:\ProgramData\PTC\Licensing\BK390206EDSTUDENTUNICL_license.dat in Notepad and inspect the line similar to the following one:

INCREMENT CREOPMA_Student2 ptc_d 33.0 23-may-2014 uncounted \

The date present in the line is expiration date of your license.

According to my past experience, the Student license is valid of one year, only. When it expires, the student must requst the new license.

Martin Hanak

Terms & ConditionsAccessibility statement