cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Your Friends List is a way to easily have access to the community members that you interact with the most! X

Bending table with Part Co-ordinate system

amitshah
1-Newbie

Bending table with Part Co-ordinate system

Hi,

Can anyone help me to understand how can we create bending table of a pipie segment wrt part co-ordinate system in Pro/Piping.

Thanks

Amit


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 ACCEPTED SOLUTION

Accepted Solutions

I give directions for doing this in my desktop instructions here; Desktop Instructions for Piping.pdf

Hope this helps,

Arnold

View solution in original post

7 REPLIES 7

I give directions for doing this in my desktop instructions here; Desktop Instructions for Piping.pdf

Hope this helps,

Arnold

Hi Arnold,

In your suggested PDF I could not able to retrieve the Bend location table in drawing. I could able to reproduce till page#14, but how to get the table in drawing.

Can you please throw light on the same.

Amit

Hello Amit.

Place this table in your drawing.  This should show the bend information.

Thanks,

Arnold

Sorry Arnold, Could not able to derive the bend information in the table file after placing in drawing.

Attached image is for your reference.

Thanks

Amit

Capture.JPG

Did you remember to "Select the “Designate for Report Setup” checkbox", as described in 4.8.4?

Hi Arnold,

I really skipped to check "Designate for Report Setup". It is working fine now.

I have a question, where that Bend table file got saved? And How to retrieve it into the drawings?It worked fine with the table file you shared, but wanted to understand how it worked.

Thanks

Sorry it took me so long to reply.  I've been covered up at work.  Save the table file to your hard drive or server, then browse to it when you go to insert into the drawing.  The bend information is saved with the piping assembly and is read from it to populate the table.

Thanks,

Arnold

Top Tags