Skip to main content
amitshah1-Visitor
1-Visitor
Sep 18, 2015 9:55 AM UTC
Solved

Bending table with Part Co-ordinate system

Hi,

Can anyone help me to understand how can we create bending table of a pipie segment wrt part co-ordinate system in Pro/Piping.

Thanks

Amit


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
ArnoldCollettAnswer
12-Amethyst
Sep 19, 2015 5:31 PM UTC

I give directions for doing this in my desktop instructions here; Desktop Instructions for Piping.pdf

Hope this helps,

Arnold

View in thread

7 replies

ArnoldCollett12-AmethystAnswer
12-Amethyst
Sep 19, 2015 5:31 PM UTC

I give directions for doing this in my desktop instructions here; Desktop Instructions for Piping.pdf

Hope this helps,

Arnold

Translate
amitshah1-VisitorAuthor
1-Visitor
Sep 22, 2015 11:14 AM UTC

Hi Arnold,

In your suggested PDF I could not able to retrieve the Bend location table in drawing. I could able to reproduce till page#14, but how to get the table in drawing.

Can you please throw light on the same.

Amit

Translate
ArnoldCollett12-Amethyst
12-Amethyst
Sep 25, 2015 1:56 PM UTC

Hello Amit.

Place this table in your drawing.  This should show the bend information.

Thanks,

Arnold

Translate
Terms & ConditionsAccessibility statement