Cannot edit dimensions in sketcher any more

16 replies
13456 views
Translate All

Dear all,

I am running into the strangest problem: for some reason in Creo 8.0.5.0, when I double-click a dimension in the Sketcher, I cannot edit it any more. The text input appears but disappears instantly again. Only when I am very, very fast in entering a new number, I can edit the dimension. There is no apparent reason why this happens, it started all of a sudden.

Running in win32_gdi-mode, and re-installing Creo did not help.

Has this been seen before?

D

Dario73Answer

13-Aquamarine

Hi,

the problem is in the home page of the browser. You can handle this by setting the option in config.pro:

web_browser_homepage about:blank

Dario

M

MartinHanak

24-Ruby III

@RV_8071958 wrote:

Dear all,

I am running into the strangest problem: for some reason in Creo 8.0.5.0, when I double-click a dimension in the Sketcher, I cannot edit it any more. The text input appears but disappears instantly again. Only when I am very, very fast in entering a new number, I can edit the dimension. There is no apparent reason why this happens, it started all of a sudden.

Running in win32_gdi-mode, and re-installing Creo did not help.

Has this been seen before?

Hi,

maybe there is a collision with another software.

Please read https://community.ptc.com/t5/PTC-Education-Forum/Error-editing-sketch-dimensions/m-p/862801 discussion.

Translate

R

RV_8071958

Author

1-Visitor

Thanks for your reply, I did not find that topic during searching, it however does show the exact same issue. I changed my regional settings in Windows quite recently to have a dot as decimal separator (comma is standard here in the Netherlands), so I was quite hopeful that reverting my changes might solve the problem. Unfortunately, no luck. I also don't recall installing any software that might interfere based on keyboard events, but I'll look further.

Translate

M

MartinHanak

24-Ruby III

@RV_8071958 wrote:

Thanks for your reply, I did not find that topic during searching, it however does show the exact same issue. I changed my regional settings in Windows quite recently to have a dot as decimal separator (comma is standard here in the Netherlands), so I was quite hopeful that reverting my changes might solve the problem. Unfortunately, no luck. I also don't recall installing any software that might interfere based on keyboard events, but I'll look further.

Hi,

if Creo is installed on more than 1 computer, you can test another computer and compare software list from both computers.

Translate