Skip to main content
2-Explorer
Mar 27, 2015 1:25 PM UTC
Question

Family Table BOM Balloon

Hello,

I have an assembly with two instances into family table. I have generated drawing from the main file and created repeat region of Two-D type to accommodate BOM in a single table for all instances.

Issue I am facing is that even though it is a repeat region, the same table is not being recognised as repeat region when I intended to do ballooning of view using Create Balloons - All.

Requesting help on this.

I am open to share my test parts on which I am facing issue for your better understanding if required.

Thanks and Regards

Ketan


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

7 replies

TomU
23-Emerald IV
Mar 27, 2015 2:37 PM UTC

Ketan,

If you are willing to use the advanced editor and upload your parts and drawings, I am willing to take a look at them.

Tom

Translate
2-Explorer
Mar 27, 2015 3:18 PM UTC

I am more interested in to do ballooning of view having family table instances. I am also not able to find how to attach parts?

Translate
2-Explorer
Mar 27, 2015 5:34 PM UTC

Hi,

Please find attached model.

Regards

Ketan

Translate