Skip to main content
khoward7-Bedrock
7-Bedrock
Jul 2, 2021 7:44 PM UTC
Question

IsoDraw 7.3 Fillet

I am using IsoDraw 7.3 build M080 build 6 currently. I am working on creating a graphic and was using the "Fillet" command and all was well, then all of sudden the program stop trimming the ellipse and the line segments. I have tried exiting the program and coming back in with no luck.

 

Has anyone had this happen? I don't know if I might have hit a key or something. It is really puzzling that it was working fine then all of sudden stopped working correctly.

 

Any thoughts or suggestions are welcome.

 

Keith

2 replies

bfriesen
bfriesen18-Opal
18-Opal
Jul 5, 2021 12:15 PM UTC

Have you renamed the preferences file under the C:\Users\username\AppData\Roaming\PTC\IsoDraw\Preferences. We found that when things go sideways with Isodraw this is a good place to look as it stores the preferences.

 

Bryon

Translate
khoward7-BedrockAuthor
7-Bedrock
Jul 6, 2021 1:44 PM UTC

Thanks Byron.

 

I did have to replace that file I will check it out and make sure everything is correct in the file.

 

Keith

Translate
Terms & ConditionsAccessibility statement