Check out this video on Creo Parametric Design Automation Tips and Techniques session from PTC Application Engineers and CadActive (PTC Partner).
Presenters: Phil Clukies (Account Manager, CadActive), Ben Bowman (Solutions Engineer, CadActive) and Ryan Butcher (Solution Consulting, Fellow, PTC).
Creo Design Automation Learning
- Chapters
- descriptions off, selected
- captions settings, opens captions settings dialog
- captions off, selected
This is a modal window.
Beginning of dialog window. Escape will cancel and close the window.
End of dialog window.
This is a modal window. This modal can be closed by pressing the Escape key or activating the close button.
- Mark as Read
- Mark as New
- Bookmark
- Permalink
- Notify Moderator
WEBCAST Q&A
Question from Anonymous: Which release of Creo are we looking at right now, with this custom tab? How was the custom tab built? Pro/Toolkit?
Answer: The tab is built with Pro/Toolkit and works with any version/release of Creo back to Creo 4.
- Mark as Read
- Mark as New
- Bookmark
- Permalink
- Notify Moderator
WEBCAST Q&A
Question from Carey: Envelopes are not common but should be explained as well.
Answer: We have covered this topic in a past TnT session. Those recordings are available at Community.ptc.com. Look for Large Assembly Management.
- Mark as Read
- Mark as New
- Bookmark
- Permalink
- Notify Moderator
WEBCAST Q&A
Question from Paul: Can you have a global config file?
Answer: Yes.