cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Visit the PTCooler (the community lounge) to get to know your fellow community members and check out some of Dale's Friday Humor posts! X

Add Datum Axis for all the Holes in Parts built from Neutral Files

abolovan
1-Newbie

Add Datum Axis for all the Holes in Parts built from Neutral Files

Hello all,

I'm looking for an application that will add datum axis for all the holes in a part generated via importing neutral files.

We use these parts for programming (Pro/NC) - mostly plates with lots of holes on all faces.

We have a large library of UDFS built for native Pro/E files and they ask for axis selection, therefore it would save a lot of time to prepare these parts and add all the axis before working on the manufacturing file.

Any suggestion is appreciated,

Thanks a lot,

Anca

1 ACCEPTED SOLUTION

Accepted Solutions
TomU
23-Emerald IV
(To:abolovan)

There is a free Toolkit application called "AutoAxis" that will do what you're looking for.  I haven't used it since back on Wildfire 2, but it looks like it's still available.  Take a look at these links:

https://support.ptc.com/appserver/cs/view/solution.jsp?n=CS48511

AutoAxis Windows 7 64bit

View solution in original post

5 REPLIES 5
TomU
23-Emerald IV
(To:abolovan)

There is a free Toolkit application called "AutoAxis" that will do what you're looking for.  I haven't used it since back on Wildfire 2, but it looks like it's still available.  Take a look at these links:

https://support.ptc.com/appserver/cs/view/solution.jsp?n=CS48511

AutoAxis Windows 7 64bit

thien94qn
3-Visitor
(To:TomU)

Can someone of you, share this AutoAxis compiled application?

Thank you very much in advance.

Regards,

My email thien94qn@gmail.com

can you share me. I need it very much. thank you, my gmail phucloi.2311@gmail.com

TomU
23-Emerald IV
(To:abolovan)

By the way, here is a nice guide on how to install it:

http://www.codexcreo.com/setup_use_of_autoaxis.pdf

Brilliant!!! It’s exactly what I was looking for. Actually is even more because it's grouping the axis based on diameter

Thank you so much, Anca

Top Tags