Skip to main content
G
Gregchop1-Visitor
1-Visitor
July 5, 2018
Question

Creo 5.0 Student License

  • July 5, 2018
  • 4 replies
  • 36082 views

I followed the directions for install and license, however when I try to launch any of the Creo Application they return a license error, even though the license is located correctly. I would note that Creo Direct on launch just terminates without message where the other 4 applications return a license error, when I select OK the application(s) close

    4 replies

    G
    Gregchop1-VisitorAuthor
    1-Visitor
    July 5, 2018

    Seems you dont have a student license for 5.0 is that correct ?

      F
      FraRob1-Visitor
      1-Visitor
      July 6, 2018

      Hi, I have the same problem: I have both installed Creo 5.0 following the instructions provided from PTC and gone through the configuration process described by PTC in the "School Configuration Guide", although when I run the program it shows me a message that says: "License request failed for feature". I'm not an expert of computers and I have no clou what that means, if you know what the problem is could you please tell me and maybe suggest me what I can do to solve it?

      Thank you

      M
      MartinHanak24-Ruby III
      24-Ruby III
      September 14, 2018

      Hi,

      if you want to install Creo Parametric 5.0, then:

      1.] remove all files from C:\ProgramData\PTC\Licensing directory (move them into other directory)

      2.] install Creo Parametric 5.0 and use Product code BE500806EDSTUDENTEDK12 to get Student license.

       

        V
        24-Ruby III
        VladimirN24-Ruby III
        24-Ruby III
        September 5, 2018

        Please submit your request in "Academic Support Request" form: Academic Case Logger

        V
        v-k-s1-Visitor
        1-Visitor
        December 5, 2018

        just do this 

        1) uninstall creo parametric 5.0 (only) and 

        2) remove licencing files permanently from your machine , from recycle bin also 

        2) go to setup again and start installing 

        3) in licencing use code:- BK500806ED0790-Y3M9-4RW5 

         

        4) enter your ID and password and click install 

         

        restart your machine 

        good to go 

        let me this worked for u or not 

          E
          eraytipton1-Visitor
          1-Visitor
          December 6, 2018

          Worked for me, thank you for the help!

          R
          rohitpremoo71-Visitor
          1-Visitor
          April 27, 2020

          licence has changed for creo 5.0. Use "BK500806ED0790-Y3M9-4RW5" and follow same process from starting. It will work.

           

          Terms & ConditionsCookie settingsAccessibility statement