converting legacy files
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
converting legacy files
Solved! Go to Solution.
- Labels:
-
Installation
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
As stated in article CS22570:
- Mathcad Prime 7 and above converter utilizes the built-in Mathcad 15 engine
- Converter is supposed to be applicable on any file which can be opened with Mathcad 15
- Converted files can be retrieved with Mathcad Prime (7 and above) as normal
Validation: The 4 examples have all converted well.
With regards, M.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Hi,
What version of Mathcad created the *.MCD files?
Prime 7 comes with a converter that converts Mathcad to Prime but you need to check the version of Mathcad is not too early?
To test this upload one of the mcd files and the converter can be tried and we can pdf the results so you can see it.
Cheers
Terry
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Hi
The first line of the *.mcd has a code.
.MCAD 304020000 1 372 202 0
but I don't know how to decipher the code.
Best to try a file for you.
Cheers
Terry
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
connect to me directly at plopath@teclens.com
thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
If you don't have many files, you can attach them all in one archive here.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
As stated in article CS22570:
- Mathcad Prime 7 and above converter utilizes the built-in Mathcad 15 engine
- Converter is supposed to be applicable on any file which can be opened with Mathcad 15
- Converted files can be retrieved with Mathcad Prime (7 and above) as normal
Validation: The 4 examples have all converted well.
With regards, M.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
A .MCAD304 file is created by Mathcad (not Prime!) version 6.
I get the specific code 304020000 when saving from Mathcad 11 down to 6.
A file saved from native Mathcad 6 has 304000000.
Is it true that the Prime7 converter might not handle certain .mcd files because they're too 'old'?
I'd be curious to know. Attached are a few files to try out.
Luc