CAD Doc vs Part BOM - sub assemblies not rebuilding

Forum|Forum|2 years ago
November 13, 2023
1 reply
3189 views

Hello,

I am unable to get the Part BOM to populate correctly, I have associated the parts in the single level but in the multi-level, the part is not recognizing it. i am not sure how to fix this or what the root cause it. anyone else ever had this issue or have i misunderstood how to associate the part

Creo 6 + Windchill 11

BOM_Platform Mgmt

Best answer by AnthonyC

the set up was not done correctly from our system and was fixed by the admin from the provider. thanks everyone for contributing.

avillanueva

23-Emerald I

There could be a number of reasons why it did not built. If the association to the CAD model and its part is not OWNER, Image or Contributing Image, it would not appear on the WTPart structure. If the WTPart was deleted at some point in the past, it could not build. You are in the right UI since I believe there is a way to have that correct the deletion and build it. I just forget off the top of my head where that was.

A

AnthonyC

Author

12-Amethyst

my CAD model and the part are linked as owner/child.

i looked a bit deeper, and looking into the WTpart BOM shows that only the item master is loading in for some reason. is there an easy way to switch from item master to child?