Skip to main content
effpt31-Visitor
1-Visitor
March 28, 2019
Solved

analytics watcher installation guide

How to install thingwatcher for analytics?

cmorfinAnswer
19-Tanzanite
March 28, 2019

Hi @effpt3 

 

The way to setup Anomaly detection differs depending on the version of ThingWorx you are using.

For release 8.4, check https://www.ptc.com/en/support/article?n=CS299231

For release 8.3 and below, check https://www.ptc.com/en/support/article?n=CS265488

https://www.ptc.com/en/support/article?n=CS302358 is also probably an interesting read to get started with Anomaly detection.

 

Hope this helps

Kind regards

Christophe

 

View in thread

7 replies

cmorfin19-TanzaniteAnswer
19-Tanzanite
March 28, 2019

Hi @effpt3 

 

The way to setup Anomaly detection differs depending on the version of ThingWorx you are using.

For release 8.4, check https://www.ptc.com/en/support/article?n=CS299231

For release 8.3 and below, check https://www.ptc.com/en/support/article?n=CS265488

https://www.ptc.com/en/support/article?n=CS302358 is also probably an interesting read to get started with Anomaly detection.

 

Hope this helps

Kind regards

Christophe

 

Translate
Surekha1-Visitor
1-Visitor
March 29, 2019

Hii @cmorfin 

Is it mandatory to connect KepServer for the sake of Anamoly Detection.

Translate
cmorfin19-Tanzanite
19-Tanzanite
March 29, 2019

Hi @Surekha 

 

No, not at all, it is presented this way in the 8.3 article only as a way to get some input data but Kepware is in no way mandatory.

All you need is to have a property that receives a signal as its value.

 

Hope this helps

Kind regards

Christophe

 

Translate
abarki5-Regular Member
5-Regular Member
May 6, 2019

Hi @Surekha,

 

If you got a solution to your question, kindly mark the answer as a accepted solution. 🐵

Else, please provide feedback in the Post.

 

Thank you.

Asia 

Translate
Terms & ConditionsAccessibility statement