Skip to main content
P
ppierce1-Visitor
1-Visitor
May 22, 2019
Solved

Floating Point number truncation

  • May 22, 2019
  • 1 reply
  • 1189 views

Hi,

 

I have a set of data coming in to thingworx from an industrial thing via opc aggregator. The data is fine in a Mashup as i can control the number of places of decimal in the mashup control...

But when I send this data to vuforia, there is no control of places of decimal so I'm getting huge data values.

 

Is there any way to control this in thingworx to control places of decimal at the "industrial thing" level?

 

Thanks,

Paul. 

Best answer by tmccombie

Hi Paul,

 

You can add data filters on your bindings within Vuforia Studio to control the length of data being displayed. This post may be helpful: https://community.ptc.com/t5/Studio/Can-t-round-digtial-value-with-decimal-part-of-a-properties/m-p/607175#M5609

1 reply

T
tmccombie21-Topaz IAnswer
21-Topaz I
May 22, 2019

Hi Paul,

 

You can add data filters on your bindings within Vuforia Studio to control the length of data being displayed. This post may be helpful: https://community.ptc.com/t5/Studio/Can-t-round-digtial-value-with-decimal-part-of-a-properties/m-p/607175#M5609

    Terms & ConditionsAccessibility statement