Skip to main content
10-Marble
Apr 29, 2016 3:01 PM UTC
Solved

Intralink 10.2 CAD-Worker

If using Windchill/Intralink 10.2 (not pdmlink) can a "CAD Worker" be configured to create exported STEP during the release workflow?

2-Explorer
Apr 29, 2016 3:35 PM UTC

I don't have access to a Pro/Intralink now to verify, but   this is possible in Windchill where you can create a publishing rule to generate STEP from worker. if you are using promotion object for release, there is a preference that push a publishing right after Promotion creation. If you are using any other workflow, you can trigger a publishing from workflow too.

I believe this is possible in Pro/Intralink as it uses same codebase, just by removing support for enterprise part. More over  PTC has Pro/Intralink in "applies to" of this CS - https://support.ptc.com/appserver/cs/view/solution.jsp?n=CS81396.

So it is a yes

Regards,

Binesh Kumar

2 replies

2-Explorer
Apr 29, 2016 3:35 PM UTC

I don't have access to a Pro/Intralink now to verify, but   this is possible in Windchill where you can create a publishing rule to generate STEP from worker. if you are using promotion object for release, there is a preference that push a publishing right after Promotion creation. If you are using any other workflow, you can trigger a publishing from workflow too.

I believe this is possible in Pro/Intralink as it uses same codebase, just by removing support for enterprise part. More over  PTC has Pro/Intralink in "applies to" of this CS - https://support.ptc.com/appserver/cs/view/solution.jsp?n=CS81396.

So it is a yes

Regards,

Binesh Kumar

Translate
10-Marble
Apr 29, 2016 6:02 PM UTC

Binesh, Once again I can not thank you enough for your help.

Translate