Skip to main content
S
Staron1-Visitor
1-Visitor
January 30, 2015
Question

Upload and check in problem

  • January 30, 2015
  • 3 replies
  • 1917 views

My Check In to Windchill fails, and I get this error “No more than one attribute value is allowed”. This assembly has been checked in earlier, all I did was to check it out and make some drawings. There are no errors, model is green.

Anyone has seen this message before, or could help me understand why it shows?

3 replies

S
Staron1-VisitorAuthor
1-Visitor
January 30, 2015

Some extra info. I did an undo check-out from Windchill (10.01), both drawing an assembly, then moved the view a bit, saved and checked in with no problems. Then I did check out the same drawing and assembly, and added a few dimension, then it won’t check in and I get the attribute error.

CraigPater
CraigPater20-Turquoise
20-Turquoise
February 3, 2015

Does the WinDU DuplicateIBAValuesCheck task report any issue (CS153384)?

S
Staron1-VisitorAuthor
1-Visitor
February 4, 2015

Hi, and thanks for reply Craig.

I have been on the “phone” with support, and they had no clue on what caused it, we have fixed it now, but that was by exporting windchill to a new temporary local folder, then delete workspace and windchill occurrences, cause the problem was only on the server. Approved By, Review Date, Reviewer, Approved By and Approval Date had all “ -,- “ on the server, but the workspace version of the file did not have had value, there is where the “ – “. So hopefully it’s a long time until I see this error again.

Terms & ConditionsAccessibility statement