Skip to main content
H
HR_1075067912-Amethyst
12-Amethyst
September 13, 2023
Solved

Visualization Issue in Windchill (12.1.0.3)

  • September 13, 2023
  • 2 replies
  • 888 views

Hello,

 

Visualization in my DEV server is not getting generated for some of the objects, I am getting an error saying, "Error: Config builder was not found for id: PSB.vizLE". Has anyone faced this error before, if so, please provide your inputs on the resolution.

 

Note: The issue is not being observed in all objects, only in some of them.

 

Thanks,

Sha

 

    Best answer by HR_10750679

    Turned out the issue could be any one of the below cases.

     

    i) The representation in the associated CAD Document has some issue, republishing the representation may fix the issue.

    ii) The link between the WTPart and CAD Document may not have been built or has an issue, rebuilding the link could fix the issue.

    2 replies

    avillanueva
    23-Emerald I
    avillanueva23-Emerald I
    23-Emerald I
    September 13, 2023

    https://www.ptc.com/en/support/article/CS358340?source=search

    https://www.ptc.com/en/support/article/CS329876?source=search

    https://www.ptc.com/en/support/article/CS357621?source=search

    This is what popped up in knowledge base. Are you using MPMLink?

     

      H
      HR_1075067912-AmethystAuthorAnswer
      12-Amethyst
      October 10, 2023

      Turned out the issue could be any one of the below cases.

       

      i) The representation in the associated CAD Document has some issue, republishing the representation may fix the issue.

      ii) The link between the WTPart and CAD Document may not have been built or has an issue, rebuilding the link could fix the issue.

        Terms & ConditionsCookie settingsAccessibility statement