Question
Auto Place
I was wondering how auto place is working for people. I was trying out
auto place in Wildfire 4 and it seems a bit flakey. I was trying to
place a cap screw in a hole and was having less than stellar success.
If I clicked near a hole on a thin sheetmetal part in an assembly it
would often come up with a hole deeper (into the screen-wise) in the
assembly. When it did get the right hole it would come up with a
solution where the screw was up side down but not offer a solution for
right side up.
Thanks,
Michael Cormack
NACCO Materials Handling Group
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
auto place in Wildfire 4 and it seems a bit flakey. I was trying to
place a cap screw in a hole and was having less than stellar success.
If I clicked near a hole on a thin sheetmetal part in an assembly it
would often come up with a hole deeper (into the screen-wise) in the
assembly. When it did get the right hole it would come up with a
solution where the screw was up side down but not offer a solution for
right side up.
Thanks,
Michael Cormack
NACCO Materials Handling Group
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.