Question
Bitmaps in drawings???
I know it has been asked before and there is smoke and mirrors involved, but
are there any new tricks to getting bitmaps to show up in drawings. I know
it is related to the OLE interface and was wondering if anyone has found a
way to repair this problem in WF4.
--
Ron Rich
Staff Mechanical Engineer
Keithley Instruments
28775 Aurora Rd.
Solon, OH 44139
PH. 440-498-2842
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
are there any new tricks to getting bitmaps to show up in drawings. I know
it is related to the OLE interface and was wondering if anyone has found a
way to repair this problem in WF4.
--
Ron Rich
Staff Mechanical Engineer
Keithley Instruments
28775 Aurora Rd.
Solon, OH 44139
PH. 440-498-2842
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.