Skip to main content
P
ptc-30817691-Visitor
1-Visitor
February 6, 2010
Question

Chamfers in 2D?

  • February 6, 2010
  • 1 reply
  • 1521 views

I'm an old ME10 guy new to CoCreate Modeling, and I recall there being a simple Chamfer function that would allow quick chamfering of a corner. I see something like that in 3D, but nothing in 2D. There's a Fillet button in 2D Annotation; is there a similar one for Chamfer that I'm not seeing?


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

1 reply

R
rswartz1-Visitor
1-Visitor
February 8, 2010
Why would you create a 2D Chamfer when there is a 3D function available? Blends and chamfers should always be done on the 3D model. They will retain their properties when you perform any additional 3D modifications to the geometry that is blended or chamfered.
Terms & ConditionsAccessibility statement