Skip to main content
M
Mickyd11-Visitor
1-Visitor
September 19, 2013
Question

Changing a post

  • September 19, 2013
  • 1 reply
  • 1052 views

Hello

i need to change the parameters in cycle 83 peck drilling in my post,any ideas how to do this?

Thanks mick


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

1 reply

P
ptc-29836331-Visitor
1-Visitor
February 2, 2014

give me your post and i help you

use creo create drill milling nc to have position,after replay Gxxx to g73/g83 ...if you want

Terms & ConditionsAccessibility statement