Question
convert insert to pin joint? WF4
It used to be pretty simple to convert an insert to a pin joint back in WF2.
I'm on WF4 and I don't see any obvious way to do this.
I'm trying to convert the shackle on a hoist ring to a mechanisim constraint so I can drag it in the top assy to create some views for a critical lift safety note.
David Haigh
Phone: 925-424-3931
Fax: 925-423-7496
Lawrence Livermore National Lab
7000 East Ave, L-362
Livermore, CA 94550
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
I'm on WF4 and I don't see any obvious way to do this.
I'm trying to convert the shackle on a hoist ring to a mechanisim constraint so I can drag it in the top assy to create some views for a critical lift safety note.
David Haigh
Phone: 925-424-3931
Fax: 925-423-7496
Lawrence Livermore National Lab
7000 East Ave, L-362
Livermore, CA 94550
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.