Skip to main content
D
dgschaefer21-Topaz II
21-Topaz II
April 30, 2012
Question

Creo 1.0 - Creo 2.0 Upgrade License Server?

  • April 30, 2012
  • 5 replies
  • 1253 views
We currently have WF4 - Creo 1.0 installed and running and need to get
Creo 2.0 going. Usually, but not always, a new version means an upgrade
to the license server. This doc:



http://www.ptc.com/WCMS/files/138523/en/Creo_2_readmefirst.pdf



Design Central
Columbus, Ohio


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

5 replies

T
TomU23-Emerald IV
23-Emerald IV
April 30, 2012
We are currently running FlexNet 10.8. To add support for Creo 2.0, I simply replaced the relevant sections in the existing license.dat file with the new sections from a new license file (with the license service stopped of course). No issues whatsoever.

Tom Uminn
Engineering Systems Analyst
trans-matic Mfg.
616-820-2499
-<">mailto:->


D
Dmi3U15-Moonstone
15-Moonstone
April 30, 2012
Doug, I guess I read it the same way as your IT guy. So I Started looking for FlexNET 11.+ for Sun Solaris from PTC - there is NONE. PTC TC confirmed that you do not need to upgrade from FlexNET 10.8 - just swap the license file. It worked.

D
D
davehaigh13-Aquamarine
13-Aquamarine
April 30, 2012
Just to chime in with everyone else. No need to upgrade the license server software, just change out the license file. Works for me, no problems.

David Haigh
B
bgruman1-Visitor
1-Visitor
May 1, 2012
I was able to do a simple file swap from WF4 to Creo2.
Opened LMTools, stopped the server, read the new file, started the server,
All OK.
Doesn't get much easier than that.

Good Luck
Bernie

Bernie Gruman
Owner / Designer / Builder
www.GrumanCreations.com



On Mon, Apr 30, 2012 at 2:24 PM, Doug Schaefer <
> wrote:

> We currently have WF4 – Creo 1.0 installed and running and need to get
> Creo 2.0 going. Usually, but not always, a new version means an upgrade to
> the license server. This doc:****
>
> ** **
>
> http://www.ptc.com/WCMS/files/138523/en/Creo_2_readmefirst.pdf****
J
jer3d11-Visitor
1-Visitor
May 1, 2012
Simply updating the license file worked for us.



All the best,
Jered

Terms & ConditionsAccessibility statement