Skip to main content
Dale_Rosema
Dale_Rosema23-Emerald III
23-Emerald III
August 28, 2012
Question

Creo 2.0 Stuck in a drawing

  • August 28, 2012
  • 1 reply
  • 3395 views

I have three drawings and one model open. I used the box in the top bar to go from one to the other. I had initially tried Alt-tabbing between then, but then they are not activiated. Now I am back on the one, and I try to get to the model, but it still shows one of the drawings with the don't symbol (red circle with a red line through it) when I click on the model. If I click on any of the drawings, then are activated, but when I click on the model, it stay on a drawing and is not activated.

Thanks,

Dale


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

1 reply

Dale_Rosema
Dale_Rosema23-Emerald IIIAuthor
23-Emerald III
August 28, 2012

Short term work around. I am dragging the window with the drawing that it is stuck on out of the way enough and then I can work on the model of the screen underneath and when I am done, I move the window back into place. Any clues as to what is happening?

B
Bari14-Alexandrite
14-Alexandrite
August 28, 2012

You can ALT + TAB to go to the desired part/drawing and then CTRL + A to activate it.

Or you can use the WINDOWS command to go and activate the desired Part/Drawing.

qwe.jpg

Dale_Rosema
Dale_Rosema23-Emerald IIIAuthor
23-Emerald III
August 29, 2012

The part was activated, but it didn't bring it to the front when I used the drop down menu in your picture. Is was still under / below the drawing window that was no longer activated.

Terms & ConditionsAccessibility statement