Skip to main content
DanielYoder1-Visitor
1-Visitor
October 28, 2012
Question

Creo / WF 5.0 Graphics problem

  • October 28, 2012
  • 2 replies
  • 1506 views

Hi All,

I have a T60 Lenovo laptop with CREO 2.0 and WF 5.0 installed. In CREO when I zoom in on an assembly, or a part, the geometry of the part if in the upper top of the screen or either side does a blur, like it gets extruded upward. The same assembly on the same laptop does not do this. Any ideas what I can do?

TIA Cadmandu


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

2 replies

ptc-47408611-Visitor
1-Visitor
November 14, 2012

Just a though -- I had some unexpected problems with graphics on my Lenovo laptop. I went to the Lenovo site and downloaded and installed an updated video drive, and all was well.

    AndréLuizM.Guim1-Visitor
    1-Visitor
    November 14, 2012

    On my desktop the same thing is happening.

    Terms & ConditionsAccessibility statement