Skip to main content
P
ptc-17737241-Visitor
1-Visitor
October 24, 2014
Question

Datum targets on multiple views and multiple sheets

  • October 24, 2014
  • 1 reply
  • 2460 views

Is there a way to show datum targets spanning multiple views and sheets of a drawing? I'm able to show the annotations on sheet one but the "Show Annotation" field is blank on the sheet two.

What am I doing wrong?


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

1 reply

T
TomD.inPDX17-Peridot
17-Peridot
October 24, 2014

Datums should allow multiple instances in valid orientations. Dimensions only show in one location.

P
ptc-17737241-VisitorAuthor
1-Visitor
October 27, 2014

I'm able to show datums without any problem. It's the datum targets that only show up on one page.

T
TomD.inPDX17-Peridot
17-Peridot
October 27, 2014

Now that would be silly, woundn't it. You might submit this as a support case.

Terms & ConditionsAccessibility statement