Skip to main content
N
nrollins2-Explorer
2-Explorer
March 12, 2014
Question

delete intralink created parameters

  • March 12, 2014
  • 13 replies
  • 3106 views
Hi all,



I have parts that are being taken out of intralink and I need to have their
parameters stripped. I cannot find / remember how to do that - But I know
that I have done it before. Anyone know how?



Thanks



-Nate


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

13 replies

Show previous replies
N
nrollins2-ExplorerAuthor
2-Explorer
March 13, 2014
Thanks everyone for your help!



I am all set with the task, but hopefully your extra tips will help Hugo…



The “no relations” hint is priceless and could save some head scratching.



-Nate


L
LEONIDGUREVICH1-Visitor
1-Visitor
March 13, 2014
I'm not sure about "The config option allow_create_pdm_param has been around since R200i2."
because in my text written:

!***TAN 133630 This option only works with Wildfire 2.0 M220 and Wildfire 3.0 M030 and later builds
allow_create_pdm_param yes

[cid:image004.jpg@01CF3ECA.B2A509B0]
H
HugoHermans12-Amethyst
12-Amethyst
March 13, 2014
I jumped a little bit too quick on conclusions. I read the posting of Olaf again, and Olaf is saying the same thing, you have to be disconnected. So Mike and Olaf, thank you.

Regards, Hugo.
Terms & ConditionsAccessibility statement