Designing Sheetmetal Pen Clip

Forum|Forum|11 years ago
May 18, 2015
2 replies
2635 views

Hi all,

I am trying to design Pen clip in Creo's sheetmetal environment, I've seen Inventor is capable of doing the same.

If possible kindly help me with the design, attached is the complete parametric 2D drawing as well.

A rough draft will also work!

Pls help.

Thanks,

Shashank

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

1_Luxor-pen-clip.pdf

Surfacing

M

mpeterson

1-Visitor

First of all what do you need the model for? If just to have the model I would not model in sheet metal and use surfacing and other general solid modeling features as it should be a bit easier to model. If it must be in sheet metal you can also create it in solid features and convert to sheet metal, but you will have to be careful creating the features so it will convert. I am not very experienced in the sheet metal module, but don't even know how I would go about modeling the arrow end. Good luck.