Dynamic editing in Assemblies

Hello All,

I have build up a flexible tube with points and curve (spline).

These tube I add to my assembly.

The end- and start-Point of the tube is guided by flexibility so that the end- and start-point

fits to my connection-point in my assemly.

But now I want to edit the curve-points between end- and start-point.

I have to do this in the assembly, because I want see where is collison,

bewtween the tubes, between other parts.

An dynamic editing is in assemblies not possible

It is only the tube-part possible (see white square at the measurement)

Why not ??

Regards

Matthias