Skip to main content
pcnelson1-Visitor
1-Visitor
June 28, 2013
Question

enable_auto_regen in Creo Elements?

  • June 28, 2013
  • 1 reply
  • 1026 views

I want to stop the automatic regen of components in an assembly. The components all prompt the user for parameter values through Pro/Program on a regen, so when the assembly is regenerated every component that is regened also prompts for values. Is there a beter way to set this up?


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

1 reply

pcnelson1-VisitorAuthor
1-Visitor
July 2, 2013

There was only one reply. Thanks to Andrew Kelly for your input. Maybe people arent using Pro/Program anymore?



I had this same problem and wrote a mapkey to pick “Current Vals”. I edited the saved mapkey to add as many “Current Vals” picks; I thought I would ever need. Little quirk in WF4 that the picks in a drawing and assembly are different, so I had to make two.Someone else suggested adding a parameter to every part and assembly to indicate whether or not the Input section of Pro/Program should run. Put an IF … END IF statement inside your INPUT … END INPUT section of the Pro/Program so that the inputs are prompted only if the value of the parameter is Yes.; Seemed kind of a pain to me to have to toggle this parameter on / off, but it’s what another company was doing

Terms & ConditionsAccessibility statement