Question
Flip Datum to bottom of GTOL reference frame
Using Creo 2 M090.
I've got a drawing with a GTOL reference frame as a free note. I have a datum flag that's anchored to it using "on GTOL", but showed up attached to the top of the GTOL reference frame. I can't figure out how to flip the flag to the bottom of the GTOL reference frame.
-- Andrew
Andrew Kelly, P.E.
Design Engineer
Honeywell Sensing and Control
2080 Arlingate Lane
Columbus, OH 43228
Office: 614-850-7818
Toll Free: 800-848-6564
Fax: 614-850-1111
andrew.kelly@honeywell.com<">mailto:andrew.kelly@honeywell.com>
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
I've got a drawing with a GTOL reference frame as a free note. I have a datum flag that's anchored to it using "on GTOL", but showed up attached to the top of the GTOL reference frame. I can't figure out how to flip the flag to the bottom of the GTOL reference frame.
-- Andrew
Andrew Kelly, P.E.
Design Engineer
Honeywell Sensing and Control
2080 Arlingate Lane
Columbus, OH 43228
Office: 614-850-7818
Toll Free: 800-848-6564
Fax: 614-850-1111
andrew.kelly@honeywell.com<">mailto:andrew.kelly@honeywell.com>
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.