Skip to main content
J
JacobD.Pierce1-Visitor
1-Visitor
September 21, 2011
Question

FLOW E

  • September 21, 2011
  • 1 reply
  • 1644 views

So I'm trying to run an analysis of a wing(it's an assembly) through Flow-E. It is just a basic extrusion ibl i slapped together. Nothing special. I'm trying to run these to make sure software is working properly before RWDC hits off. I keep getting an error message say I have to have the "heat conduction in solids" option turned on.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

1 reply

H
hkramer1-Visitor
1-Visitor
November 2, 2011

is this about Creo Elements/Direct Modeling - FE Analysis?

If so - can you please add the error message / picture or even better - in case you have active maintenance - contact your local support center to get help.

If the product does not match the Creo Elements/Direct Modeling area - you might consider to ask this question in a different product discussion board.

Terms & ConditionsAccessibility statement