Question
Modifying Coordinate System Name within a Family Table
I am building a very large family table. When I pull up each instance, I
would like to have the base coordinate system have the same name as the
component. Is there a simple way to accomplish this?
Thanks in advance.
Keith
Keith Richman
Simplified Solutions Inc.
410-420-7853 (United States)
<">mailto:-> -
<">http://www.simplifiedsolutionsinc.com>
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
would like to have the base coordinate system have the same name as the
component. Is there a simple way to accomplish this?
Thanks in advance.
Keith
Keith Richman
Simplified Solutions Inc.
410-420-7853 (United States)
<">mailto:-> -
<">http://www.simplifiedsolutionsinc.com>
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.