Skip to main content
A
Anonymous
May 4, 2018
Question

Pick entities for dimensions without ctrl?

  • May 4, 2018
  • 5 replies
  • 2587 views

Been a few release since I used Creo last.

 

I don't remember having to hold control when picking entities for dimensions. You could, but it wasn't mandatory.

 

Am I mistaken?

    5 replies

    StephenW
    StephenW23-Emerald III
    23-Emerald III
    May 4, 2018

    Sometime back, maybe Pro/e Wildfire 5, they added the "extra" ctrl key. It was supposed to make it consistent with "windows" type programs.

    D
    doneill2-Explorer
    2-Explorer
    May 8, 2019

    We are just now going to Creo 4... and this is new.

    It wasn't required in Creo 2.0

    I wonder if there is a setting I can change to put it back the old way...  

    T
    TomU23-Emerald IV
    23-Emerald IV
    May 10, 2019

    I wonder if there is a setting I can change to put it back the old way...  

    Nope.

    D
    doneill2-Explorer
    2-Explorer
    May 10, 2019

    Well... that's to the point!

    Thanks

    Terms & ConditionsAccessibility statement