Question
reuse sketch baseline dim.
Does anyone know of a method or option that will allow Creo to reuse a baseline location from a sketch in the drawing? I would like to create additional ordinate dimensions in my drawing using the baseline from the first sketch in the model tree. I've setup the sketch to have a few ordinate dimensions and have "shown" those in the drawing. But, I can't figure out how to Create any other ordinate dim's off of that "shown" (0,0) location.
Using Creo 1 (m40)
Thanks all
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Using Creo 1 (m40)
Thanks all
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.