Skip to main content
B
bmozley1-Visitor
1-Visitor
June 28, 2011
Question

rip

  • June 28, 2011
  • 1 reply
  • 844 views
I have a simple rip and a tab bent up but I can't seem to get a flat
pattern to work. I must be missing something, Do I need to merge the rip
in some way ?

See pic.



Brad


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

1 reply

M
merrill.rosenow1-Visitor
1-Visitor
June 29, 2011

I've had the flat pattern not work once or twice. It was due to very complex bending of the part. I did find though that an unbend all worked. On another odd note, after more manipulation the flat "magically" worked again. Try an unbend all.

Terms & ConditionsAccessibility statement