Question
SUMMARY & FOLLOWUP tell pro/e to ignore a certain component when running mass props analysis?
Thanks to all who suggested creating a simplified rep & running the mass
props analysis.
Now for my followup question: is it possible to report that simplified rep's
mass props (specifically in a drawing) no matter which simp rep is active?
For instance, suppose I wanted to show the master rep on a drawing, and
report the mass of both the master rep, and the simplified rep.
--
Lyle Beidler
MGS Inc
178 Muddy Creek Church Rd
Denver PA 17517
717-336-7528
Fax 717-336-0514
<">mailto:-> -
<">http://www.mgsincorporated.com>
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
props analysis.
Now for my followup question: is it possible to report that simplified rep's
mass props (specifically in a drawing) no matter which simp rep is active?
For instance, suppose I wanted to show the master rep on a drawing, and
report the mass of both the master rep, and the simplified rep.
--
Lyle Beidler
MGS Inc
178 Muddy Creek Church Rd
Denver PA 17517
717-336-7528
Fax 717-336-0514
<">mailto:-> -
<">http://www.mgsincorporated.com>
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.