Question
Sweeps on Ext Copy Geom curve
I'm puzzled...I sketched a 2D curve in a Skeleton part and then used ECG to
show it in a piece part (a section of pipe in this case which is part of a
subassembly). I'd like to just sweep a thin circle along this curve to
create my pipe but it says "Specified trajectory is not valid. Please
reselect". I have read this TPI
(
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
show it in a piece part (a section of pipe in this case which is part of a
subassembly). I'd like to just sweep a thin circle along this curve to
create my pipe but it says "Specified trajectory is not valid. Please
reselect". I have read this TPI
(
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.