10-Marble
October 25, 2012
Question
Syntax is to display the active assembly
- October 25, 2012
- 0 replies
- 477 views
Don,
Thanks for confirming that.
I was using just &asm.name but what was messing me up was I needed to
put &asm.name:3 for this particular case.
Regards,
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Thanks for confirming that.
I was using just &asm.name but what was messing me up was I needed to
put &asm.name:3 for this particular case.
Regards,
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.