Skip to main content
lsilva1-Visitor
1-Visitor
March 8, 2015
Solved

Undo component drag

  • March 8, 2015
  • 4 replies
  • 4460 views

I've clicked on Drag Components just for testing, now my assembly is messed up.

And worse: Creo saved it !

Hot to undo that ?

Ctrl+z doesn't work.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Best answer by dgschaefer

I assume your components were not fully constrained? If so, I'd redefine them and fully constrain them.

4 replies

dgschaefer21-Topaz IIAnswer
21-Topaz II
March 8, 2015

I assume your components were not fully constrained? If so, I'd redefine them and fully constrain them.

    lsilva1-VisitorAuthor
    1-Visitor
    March 8, 2015

    True

    It was not fully constrained.

    Had to do all over

    I've used the existent datum to bind the first part, instead of using the Default constraint
    That was my error...

    TomD.inPDX17-Peridot
    17-Peridot
    March 8, 2015

    Use snapshots before you drag components. This gives you a quick way back.

      Terms & ConditionsAccessibility statement