Skip to main content
Dom_CHENTRE14-Alexandrite
14-Alexandrite
August 3, 2015
Question

warp on assembly

  • August 3, 2015
  • 2 replies
  • 1197 views

Hi alls,

I'm wondering if it's possible (or ilt will be) to make a warp editing on an assembly.

If it's not, any trick to do this on assembly of few parts ?

Perhaps with relations ?

Thanks for any advices,

Dom


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

2 replies

Chris3
Chris321-Topaz I
21-Topaz I
August 3, 2015

Do you care about retaining the individual components? If not you could export to a step and then import as a part (intf3d_in_as_part Yes) and do a warp on the imported part.

Patriot_1776
Patriot_177622-Sapphire II
22-Sapphire II
August 3, 2015

To my knowledge, no.  You could do as Christpher suggests.  I WISH you could do that or, preferrably, a spinal bend on an assembly at an upper assembly level.....

Terms & ConditionsAccessibility statement