Skip to main content
B
brianlynn1-Visitor
1-Visitor
April 28, 2010
Question

What Analysis do I use.

  • April 28, 2010
  • 1 reply
  • 600 views
I rarely need to use analysis, but I have a cast part that I need to
verify all the edges have been rounded on, is there a tool for verifying
this. I have stumbled around in the analysis menu some but it is not
readily apparent to me.

Thank you,

Brian S. Lynn
Technical Coordinator, Product Engineering
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

1 reply

B
brianlynn1-VisitorAuthor
1-Visitor
April 28, 2010
Disregard the previous e-mail I found a solution. Since I was just
looking for open edges, I added a round to the end of the part and then
check All Convex Edges, checked to see what was highlighted and the turned
that off, and then checked the All Concave Edges and checked those edges,
once I verified everything that was highlighted I simply canceled the
command and no lingering effects.

Thanks to anyone who put some time in to writing something up on this,

Brian S. Lynn
Technical Coordinator, Product Engineering
Terms & ConditionsAccessibility statement