Skip to main content
V
VladimirN24-Ruby III
24-Ruby III
September 7, 2013
Question

Something is wrong with contour plots

  • September 7, 2013
  • 2 replies
  • 4707 views

Something is wrong with displaying contour plots in Mathcad 15. Everything works fine only if I create a new plot. A source file ("Contour plot_MC 2000") was created in Mathcad 2000 version. Any ideas?

2 replies

W
Werner_E25-Diamond I
25-Diamond I
September 7, 2013

Bug confirmed.

Strange thing. The area which is displayed is not adjusted to the size of the matrix.

If you increase the number of points (replace 4*... by 15*...) you begin to see something.

Could not spot any differences in the format options between the old and a newly created plot.

When I select all areas in the sheet and do a format separate regions, I get a lot of display errors like the following. The region "Injector Mass ...." would not be selectable.

displayerror.png

V
VladimirN24-Ruby IIIAuthor
24-Ruby III
September 7, 2013

The same bug occurs in Mathcad 11.0a version.

R
RichardJ19-Tanzanite
19-Tanzanite
September 7, 2013

Weird, but it's not normal behavior. Did you create the file in MC2000, or did you get it from somewhere else?

V
VladimirN24-Ruby IIIAuthor
24-Ruby III
September 7, 2013

I was looking for some calculations on acoustics and found the file here ("Analysis of Acoustic Model"):

http://romanuniverse.com/science/mathcadfiles.htm

http://romanuniverse.com/science/AcousticModel.html

http://romanuniverse.com/science/AcousticModel.mcd

P.S. Сan you test this file in 2000 version?

R
RichardJ19-Tanzanite
19-Tanzanite
September 7, 2013

P.S. Сan you test this file in 2000 version?

Only with a huge amount of trouble. I have version 2000 on CD, but it can't coexist with later versions on te same computer.

The contour plot should not have this problem though, so I think the file must be corrupted in some way.

Terms & ConditionsAccessibility statement