cero 8.0 AFX failed to load

 Hi,

1. Articles:

• "Error "AFX failed to load" appears on launching Creo Parametric": https://www.ptc.com/en/support/article/CS242960
• "Getting error "IFX failed to load" followed by "AFX failed to load" when launching Creo Parametric": https://www.ptc.com/en/support/article/CS332967

2. There was a similar question before:

• "Error after Creo 7 Student Installation": https://community.ptc.com/t5/PTC-Education-Forum/Error-after-Creo-7-Student-Installation/td-p/685985
• "Failing to enable AFX feature": https://community.ptc.com/t5/3D-Part-Assembly-Design/Failing-to-enable-AFX-feature/td-p/277789
• "Creo 7 startup": https://community.ptc.com/t5/System-Administration/Creo-7-startup/td-p/660803