Skip to main content
TDT18-Opal
18-Opal
May 23, 2024 8:50 AM UTC
Solved

Creo worker is publishing Integer 1 as I

Creo worker is publishing Integer 1 as I

Any settings to publish as 1

TDTAnswer
18-Opal
Jun 5, 2024 5:35 AM UTC

Hi Everyone,

 

Thanks for the inputs.

We had missed some of the custom font config files to deploy in worker machine.

After placing the required files, the worker is publishing as expected.

View in thread

11 replies

Hemant_Chaugule12-Amethyst
12-Amethyst
May 23, 2024 9:11 AM UTC

Do you mean for Creo drawing annotation "1" will be published as a "I"?

Translate
TDT18-OpalAuthor
18-Opal
May 23, 2024 9:41 AM UTC

@Hemant_Chaugule Yes

Translate
Hemant_Chaugule12-Amethyst
12-Amethyst
May 23, 2024 10:25 AM UTC

Then may be you can try changing below recipe file setting :

Advanced > PDF Output Setup > Font Control > Stroke Non trueType Font.


If this doesn't work, you can manually export the file from Creo to check the output and if output is good then use same value to the above recipe file,.

Translate
    joe_morton
    joe_morton19-Tanzanite
    19-Tanzanite
    May 24, 2024 6:57 PM UTC

    Does the Creo worker have the required fonts loaded? 

    Translate
    TDT18-OpalAuthor
    18-Opal
    May 27, 2024 6:46 AM UTC

    Hi @joe_morton,

     

    Is it possible to load fonts in Creo workers?

    Translate
    joe_morton
    joe_morton19-Tanzanite
    19-Tanzanite
    May 28, 2024 3:49 PM UTC

    This looks like what you need: https://www.ptc.com/en/support/article/CS32299?source=search

     

    What I mean by my comment is that it would be possible to set a default font in C:\Windows\fonts that may not exist on the CAD Worker, since it might be a different computer. So I'd recommend checking what you have set in your drawing options for default_annotation_font, update it if required, and make sure that whatever font you select is present on the CAD worker as well.

    Translate
    jlecoz15-Moonstone
    15-Moonstone
    May 27, 2024 3:32 PM UTC

    Did you applied the same Creo configuration used on the CAD workstation within the CAD worker startup dir (proeworker)?

    Translate
    vnamboodheriEmeritus
    Emeritus
    May 30, 2024 9:53 AM UTC

    Hello @TDT, 

     

    It looks like you have some responses from some community members. If any of these replies helped you solve your question please mark the appropriate reply as the Accepted Solution. 

    Of course, if you have more to share on your issue, please let the Community know so other community members can continue to help you.

    Thanks,
    Community Moderation Team.

    Translate
    Terms & ConditionsAccessibility statement