Skip to main content
jbs51-Visitor
1-Visitor
December 15, 2011
Solved

Manufacturing Symbol in Windchill 10.0

  • December 15, 2011
  • 2 replies
  • 2067 views

We have recently moved to Windchill 10.0 from Intralink 3.4. In Intralink, whenever I create a new Manufacturing assembly, it shows as a different symbol but same does not happen in PDMLink and it shows me as an assembly symbol. Please refer figure. (the manufactrung symbol which you can see in the figure are checked out assemblies which has been created and checked in at a time of Intralink.)

Any help is appreciated.

Thanks,

Jay

PlanetPTC.JPG

Best answer by Celia

Jay,

The issue arose when Creo Manufacturing assemblies removed the *.mfg and on the PDMLink side we did not catch immediately that we needed to identify the Manufacturing assembly sub category. This has been fixed only recently and will be made available in 10.0 M030.

Celia

2 replies

Celia5-Regular MemberAnswer
5-Regular Member
December 15, 2011

Jay,

The issue arose when Creo Manufacturing assemblies removed the *.mfg and on the PDMLink side we did not catch immediately that we needed to identify the Manufacturing assembly sub category. This has been fixed only recently and will be made available in 10.0 M030.

Celia

jbs51-VisitorAuthor
1-Visitor
December 15, 2011

Thanks Celia.

Jay

Terms & ConditionsAccessibility statement