Skip to main content
psobejko1-Visitor
1-Visitor
July 23, 2015
Solved

face cam - can this be done in Creo?

  • July 23, 2015
  • 3 replies
  • 2387 views

I have tried, but couldn't achieve simulating a cam where the roller-follower axis is perpendicular to the cam rotation axis.

 

I was able to make a cam connection using simpler cam where the roller-follower axis is parallel to the cam rotation axis, and drag it around in Creo 2.0.

 

 

But I'm unable to make a cam connection of something like this:

 

https://www.youtube.com/watch?v=9ZUUYZ1a4e4&feature=youtu.be

Which shows a barrel cam being dragged and follower following.

This is done in Solidworks, procedure is shown:

https://grabcad.com/questions/how-to-model-a-face-cam-or-drum-cam-pl-s-post-a-step-by-step-tutorial

 

Please advise about an on-line tutorial or provide a sample model or is this is something that just requires a different technique (3d body contacts???).


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Best answer by TomU

Sample video for you. 

Video Link : 6233

3 replies

TomU23-Emerald IV
23-Emerald IV
July 23, 2015

The best way to do this in Creo is with a point-follower connection.  Create a curve at the center of your path and then configure the roller with a point connected to this curve.

Here are some other related discussions:

    TomU23-Emerald IVAnswer
    23-Emerald IV
    July 23, 2015

    Sample video for you. 

    Video Link : 6233

      psobejko1-VisitorAuthor
      1-Visitor
      July 23, 2015

      Ok, so it is possible.  By the point-follower connection, you mean the slot type of a connection?  (referring to the model CAM_EXAMPLE_MOBIUSID.zip) in the thread you recommended (Barrel Cam Modeling)

      As a general comment, this seems to be quite difficult to achieve in Creo, especially if you compare how easy it seems to be done in Solidworks.  Can someone comment about the quality of the cam geometry and the cam simulation created by Solidworks methods?

      Terms & ConditionsAccessibility statement