Skip to main content
sdickinson-21-Visitor
1-Visitor
February 7, 2016
Solved

Issue generating Tetrix motor

  • February 7, 2016
  • 3 replies
  • 1636 views

Hi everyone! We have been having issues modeling the Tetrix motor (tetrix_739083_2012). Whenever we add it to an assembly, the part doesn't show up and we get a notice that the part failed to regenerate. We tried downloading the part again, but that did not help. Does anyone have any guidance on how to fix this problem? We are using the PTC Creo Parametric Educational Edition.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Best answer by sdickinson-2

Hello,

I was able to figure out the problem. The parts that make up the assembly were not in our directory, so once I put them in the part assembly appeared.

Thank you for your time,

Sidney

3 replies

MartinHanak24-Ruby III
24-Ruby III
February 8, 2016

Hi,

please upload Tetrix motor (tetrix_739083_2012). Use How to attach file when you Reply to a discussion. procedure.

MH

sdickinson-21-VisitorAuthorAnswer
1-Visitor
February 11, 2016

Hello,

I was able to figure out the problem. The parts that make up the assembly were not in our directory, so once I put them in the part assembly appeared.

Thank you for your time,

Sidney

Dale_Rosema
Dale_Rosema23-Emerald IV
23-Emerald IV
February 18, 2016

Don't forget to mark your answer as correct for those who may search on the issue in the future.

Terms & ConditionsAccessibility statement