Skip to main content
D
DieselPig1-Visitor
1-Visitor
May 9, 2017
Solved

Pattern Feature

  • May 9, 2017
  • 4 replies
  • 2349 views

Morning All

 

Creo will not allow me to pattern the impeller blade of the attached. I see a few historical posts of something similar, any tips or advice?

Best answer by MartinHanak

Hi,

see my solution ... I am not sure if it is the right one.

MH

4 replies

M
MartinHanak24-Ruby IIIAnswer
24-Ruby III
May 9, 2017

Hi,

see my solution ... I am not sure if it is the right one.

MH

    D
    DieselPig1-VisitorAuthor
    1-Visitor
    May 9, 2017

    Hi Martin

    One too many vanes but correct!

    Thank You.

      Dale_Rosema
      Dale_Rosema23-Emerald IV
      23-Emerald IV
      May 10, 2017

      Phil Szarko‌

      Don't forget to mark Martin answer as correct for those who come across this thread to learn about patterning.

        Terms & ConditionsAccessibility statement