Sheet metal form tool help

Forum|Forum|9 years ago
October 2, 2016
3 replies
2291 views

Hello,

I've a bit of hiccup using form tool in sheet metal. if you can see from the pictures i have done punch one over another but what i want is a punch like in the part in the attached pdf how to do so.

I want one punch over another without deforming the first punch

Any help is appreciated. and can anyone explain Diff Between Die form and Punch form in creo

Thank you

Babu

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

2_L_Shape_Bracket.pdf

1_bracket-7z.zip

Data Exchange

Best answer by RoyCrerar

Hi, In modelling terms if you really wanted this to happen then this would need to be a single tool.

The biggest issue I can see is that in my experience is that 6-7 mm is the maximum depth of feature that can be punched in turret punch/press. The feature is also very long at over 245mm so again you would need a very large tool unless it is nibbled in. In my opinion you can't make this component as it stands.

R

RoyCrerar

Answer

1-Visitor

Hi, In modelling terms if you really wanted this to happen then this would need to be a single tool.

The biggest issue I can see is that in my experience is that 6-7 mm is the maximum depth of feature that can be punched in turret punch/press. The feature is also very long at over 245mm so again you would need a very large tool unless it is nibbled in. In my opinion you can't make this component as it stands.