Question
Simple 3D Note
Creo 2, M120
In the past I've put a simple 3D note in my part & assy models, attached to an edge somewhere, to show some information like the internal volume. I put them on a layer so I can turn them on or off.
In Creo, complex annotation features have taken over and creating a simple note with a leader is evading my grasp. How do I do this?
--
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
In the past I've put a simple 3D note in my part & assy models, attached to an edge somewhere, to show some information like the internal volume. I put them on a layer so I can turn them on or off.
In Creo, complex annotation features have taken over and creating a simple note with a leader is evading my grasp. How do I do this?
--
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.